Manual

CONNECTING THE SUPPLIED ANTENNAS (2)
Connect the FM antenna to the FM 75 Q terminals and the AM
antenna to the AM LOOP terminals.
FM antenna
AM loop antenna
To stand the AM loop antenna on a surface
Fix the claw to the slot as shown in the illustration.
To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a T shape and fix its ends to
the wall.
AM loop antenna:
Position to find the best direction.
• Do not bring the FM antenna near metal objects or curtain rails.
• Do not bring the AM antenna near other external equipment,
the unit itself, the AC power cord or speaker cords, as noise
will be picked up.
• Do not unwind the AM loop antenna wire.
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is
recommended. Connect the outdoor antenna to the FM 75 ii
terminals.
CONNECTING THE SUPPLIED REMOTE
CONTROL EXTENDER (D (AV-X200 only)
Connect the HT-M301 remote control extender to the TO
REMOTE CONTROL EXTENDER jack on the rear panel.
TO REMOTE
CONTROL
EXTENDER
Position the supplied remote control extender so that the line of
sight between the remote control extender and the connected
equipment will not be obstructed by a rack or opaque glass.
REMOTE CONTROL
This remote control system can memorize other remote control
signal codes (see “MEMORIZING SIGNAL CODES”), and allows
you to operate external equipment with it through the supplied
remote control extender (AV-X200 only).
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
C>
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
• If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor in the display window is exposed to intense light, such
as direct sunlight.
- Other remote controls are used nearby (those of television,
etc.)
ENGLISH