Instruction Manual

PREPARATIONS
1
Sb'l
II
J
«◄DOWN UP^W
J
SFT
eg
j
«◄DOWN UP^M
I,
J
SET
c
II
J
= — 2,4
•!(
H It f_
I l_!^
---
Ills'
SETTING THE CLOCK
When you first connect the AC cord, the II SET button flashes to
inform you that the current time needs to be set. Set the time as
foiiows, whiie the power is stiii off.
1 Press the II SET button.
The hour fiashes.
2 Press the ◄◄ DOWN or
designate the hour.
UP button to
3 Press the II SET button to set the hour.
The hour stops flashing and the minute starts fiashing.
4 Press the DOWN or UP button to desig
nate the minute.
5 Press the II SET button to set the minute and
compiete setting.
The minute stops fiashing in the dispiay and the ciock starts
running from 00 seconds.
To set the time more accurateiy, press the II SET button when
another ciock or a time signal indicates that the current time is
00 seconds.
Each coion fiash in the dispiay indicates one second.
To correct the current time -♦ ES
Press the CLOCK button on the remote controi. The ciock is
dispiayed and the II SET button on the main unit flashes for 4
seconds.
Within this period, press the II SET button and continue by
foilowing steps 2 to 5.
To display the current time while the power is on
Press the CLOCK button on the remote control. The current time
is dispiayed for 4 seconds.
However, the time cannot be dispiayed, during recording.
To switch to the 24-hour standard
The clock is factory-set to the 12-hour standard. To switch to the
24-hour standard, press the CLOCK button on the remote control
and then press the ■ button within 4 seconds. Repeat the same
procedure to restore the 12-hour standard.
After a power interruption
If you switch the display to clock, the clock flashes to remind you
that the current time needs to be reset.
■(JLUtJK
_< _ *
I
) J
22