Instruction Manual

RADIO RECEPTION
oo<^o
ooo
oo o
oooo
CD CD CD
OOCDO
OOO
ogoo
Q o
OCiD o
^uoo
•FM MODE
MONO
-[ MOhC' j ^ f’'
FM éÉ
MANUAL TUNING
1 Press the TUNER/BAND button to select the band.
You can also select the tuner by pressing the TUNER/BAND
button with the power off. After the power comes on, press it
again as follows to select the band.
C
FM—*-AM
□
2 Press the DOWN or ►► UP button to select a
station.
Each time it is pressed, the frequency changes.
When a station is received, TUNE is displayed for 4 seconds.
During FM stereo reception, (((CS))l) is displayed.
To search for a station quickly (Auto search)
Keep the DOWN or ►► UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
The search may not stop at stations with very weak signals.
When an FM stereo broadcast is noisy
Press the FM MODE button on the remote control to display
MONO. □
Background noise is reduced, though reception is monaural.
To restore stereo reception, press the FM MODE button again to
extinguish MONO.
To change the AM tuning intervai
The AM tuning interval is factory-set to 10 kHz.
If you use this unit in an area where the frequency allocation system
is 9 kHz, change the AM tuning interval.
With the TUNER function selected, press the POWER button while
pressing the TUNER/BAND button. To reset the interval, repeat
this procedure.
NOTE
When the AM tuning interval is changed, all preset stations (see
page 44) are cleared. The preset stations have to be set again.
42