Instruction Manual
TIMER
SETTING THE TIMER
8 Get ready for the source.
In © timer playback mode
To listen to CDs
Load discs on the disc trays. Piay will begin with the disc in the most
recently used disc tray.
To listen to a tape
Insert a tape into the deck.
To listen to the tuner
Tune in to a station.
To listen to connected sources
Set an external timer to turn the connected source on and off.
(See the operating instructions of the connected source.)
(T)
In ^ timer recording mode
After the preparation for each source above, set the tape to be
recorded on into the deck. (See steps 1 to 3 on page 50.)
9 Adjust the volume and tone.
10Press the POWER button to turn the unit off.
/~\
Check to be sure that ti) or is displayed, and that the function
buttons are off. This shows that the unit is in timer standby mode.
When the timer-on time is reached, the unit will come on and play
will begin using the selected source.
Display during timer-on period
When the power is turned on by the timer, SLEEP and 60 are displayed
for 4 seconds. It shows the period of the time until the power is off.
To change the timer-on period
In step 7, during the 4 seconds that TIMER is displayed, press the
DOWN or ►► UP button to specify the timer-on period.
You can select a timer-on period between 10 and 240 minutes in 10-
minute steps.
To cancel timer standby mode temporarily
Press the TIMER button so that © or ^ goes out in the display.
To restore timer standby mode, press the TIMER button to display 0
or ©.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat steps 8 and 9 to select the correct
sources and volume.
To change the specified time and source
Carry out all the steps again.
To check the specified time and source
Press the TIMER button. The timer-on time and the selected source
name are displayed for 4 seconds..
NOTE
• Timer playback and timer recording will not begin unless the power
is turned off.
• Connected equipment cannot be turned on and off by the built-in
timer of this unit. Use an external timer.
• The timer-on period is not displayed after setting.
64