Operation Manual

MAIN OPERATION
Switching On for the first time
Plug into AC power or install batteries by following instructions on the previous Power Connection
section. Slide the FUNCTION switch to RADIO or CD/USB/AUX position to turn on the unit. The
POWER indicator will be lighted up.
Switching between different sources (Radio / CD / USB / AUX)
After turning on the unit, slide the FUNCTION switch to select different sound sources
Adjusting sound volume level
After turning on the unit, turn the VOLUME knob to adjust the level of sound volume.
Adjusting the rod antenna
The aerial should be extended to ensure good reception in both FM radio modes. It may be necessary to
adjust the position of the unit and /or aerial position to achieve the best signal reception.
Bass booster
During music playback, toggle the BASS button to turn on/off bass booster for bass enhancement.
CARE AND MAINTENANCE
*Carrying for Compact Discs
1. Treat the disc carefully. Handle the disc only by its edges. Never allow
your fingers to come in contact with the shiny, unprinted side of the disc.
2. Do not attach adhesive tape, stickers, etc. to the disc label.
3. Clean the discs periodically with a soft, lint-free, dry cloth. Never use
detergents or abrasive cleaners to clean the disc. If necessary, use a CD
cleaning kit. If a disc skips or gets stuck on a section of the disc, it is
probably dirty or damaged (scratched). When cleaning the disc, wipe in
straight lines from the center of the disc to the outer edge of the disc.
Never wipe in circular motions.
4. This unit is designed to play discs bearing the identification logo as shown here or MP3 format Disc.
Other discs may not conform to the CD standard and may not play properly.
5. Discs should be stored in their cases after each use to avoid damage.
6. Do not expose discs to direct sunlight, high humidity, high temperatures, or dust, etc. Prolonged
exposure or extreme temperatures can warp the disc.
7. Do not stick or write anything on either side of the disc. Sharp writing instruments or the ink may
damage the surface.
Care of the Cabinet
1. To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
2. The finish on your unit may be cleaned with a dust cloth and cared for as other furniture. Use caution
when cleaning and wiping the plastic parts.
3. Mild soap and a damp cloth may be used on the front panel.
To Clean the Lens
If the lens get dirty, your player may skip or may not play a CD
1. Open the CD door.
2. Use a camera lens blower/brush to blow on the lens once or twice, brush the dust or particles off the
lens then blow again.
3. To remove fingerprints, use a dry cotton swab to wipe from the middle to outer edge of the lens
15