Instruction Manual

After Sales Support

(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support

Getting Started

Unpacking

• Packaging materials: This product has been packaged to protect it against

transportation damage. Remove all packaging materials from around and inside the

appliance and keep the original packaging carton and materials in a safe place. It

will help prevent any damage if the product needs to be transported in the future,

and you can use it to store the appliance when it is not in use. In the event that the

carton is to be disposed of, please recycle all packaging materials where possible.

Plastic wrapping can be a suffocation hazard for babies and young children, so

ensure all packaging materials are out of their reach and disposed of safely.

• Parts: Check to ensure you have all the parts listed in the Product Overview section.

• Damage: When unpacking, check the appliance carefully for damage. If it is

damaged, do not install the appliance. Contact our after sales support centre for

advice on examination or return of the damaged appliance.

• Power cord: Unwind the power cord to its full length and inspect it for damage.

Do not use the appliance if the appliance or its cord has been damaged or is not

working properly. In case of damage, contact our after sales support centre for

advice on examination, repair or return of the damaged product.

• Read the manual: Before installing your new fridge, read all safety instructions,

especially the sections on installation and electrical safety on pages 4–5. Installation

instructions follow on the next page.

• Clean: Make sure the fridge is disconnected from the power supply before cleaning

the interior surfaces and all internal accessories with lukewarm water with a little

baking soda added (about 2 tablespoons of baking soda to 1 litre of water) and a

soft cloth. This will remove any dust from transit and storage and help remove the

typical smell of a brand new product. Then dry thoroughly.

IMPORTANT: Do not use harsh or abrasive detergents or powders as these will

damage the finish.

• Door opening: Your fridge has the capability of the doors opening from the right

or left side. If your set-up requires reversal of the door swing, please follow the

instructions on pages 19-23.

• Your new fridge is now ready for installation.