Instruction Manual

After Sales Support

(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support

Getting Started (Cont.)

Fig. 2

Installation

Space requirements

• Door opening: Place the unit so there

is enough space for the doors to open

easily (Fig. 1).

• Clearances: Ensure that air can

circulate freely around the back of the

cabinet, which is necessary to cool the

compressor and condenser. Allow at

least 5 cm at the sides of the unit.

• Overhanging wall units: To ensure best

performance, if the appliance is positioned below an overhanging wall unit, the

minimum distance between the top of the cabinet and the wall unit must be at least

10 cm. Ideally, however, the appliance should not be positioned below overhanging

wall units.

Levelling

The appliance must be installed level so that

it can work properly and the magnetic doors

seals are properly aligned. To level the unit, tilt

it slightly backward, then adjust the two levelling

feet at the front of the cabinet until the unit is

level (Fig. 2).

Electrical connection

• WARNING! It must be possible to disconnect

the appliance from the mains power supply;

the plug must therefore be easily accessible

after installation.

• Before plugging in your new fridge, let it stand upright for at least 4 hours.

This will allow the refrigerant gases to settle into the compressor and reduce the

possibility of a malfunction in the cooling system.

• The appliance must be earthed. The plug of the power supply cord is equipped

with a contact for this purpose. Do not under any circumstances cut or remove the

third (earth) prong from the power cord. If the plug does not fit your outlet, consult a

licensed electrician for advice to have the outlet changed.

• Plug the unit into a dedicated, properly installed and earthed wall outlet.

• Secure the power supply cord behind the unit. Do not leave it exposed or dangling

to prevent injury and accidental disconnection from the power supply.

• Adjust the temperature control as described on page 10.

• When first starting up, and after a period out of use, allow the unit to cool

down on the MAX setting for at least 2 hours before placing food in the fridge.

Fig. 1