User's Manual

After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | [e-mail]
11
Levelling the appliance
• Position the dishwasher on a level and sturdy
floor.
• If the floor is uneven, adjust the adjustable feet
until it reaches a horizontal position; just screw
the feet in or out a little (Fig. 1).
• The appliance should not be inclined more
than 2°.
• Correctly levelled, the appliance will be more
stable and much less likely to move or cause
vibrations and noise during operation.
Freestanding installation
Between existing cabinets
• The height of the dishwasher, 845mm, has
been designed in order to allow the machine
to be fitted between existing cabinets of the
same height in modern fitted kitchens (Fig. 2).
• The feet can be adjusted so that the correct
height is reached.
Underneath an existing worktop
• In most modern fitted kitchens there is only
one single worktop under which cabinets and
electrical appliances are fitted. If you want to
fit this dishwasher under an existing worktop,
you need to remove the worktop of the
dishwasher by unscrewing the screws under
the rear edge of the top (Fig. 3: a).
IMPORTANT! Keep the screws! After
removing the worktop you will have to screw
them back under the rear edge of the top
(Fig. 3: b).
• The height of the dishwasher will then be
reduced to 815mm (as per ISO regulations),
which means it should fit perfectly under your
kitchen worktop.
Installation (Cont.)
Fig. 2
Fig. 3
Fig. 1