User's Manual

After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | [e-mail]
33
Other Useful Information (Cont.)
WARNING!
• When cleaning the filters take care not to contort their shape, which could
compromise the washing performance.
• Do not overtighten the filters. Put the filters back in sequence securely,
otherwise coarse debris could get into the system and cause a blockage.
• Never use the dishwasher without the filters. Improper replacement of the filters
may reduce the washing performance and damage dishes and utensils.
Cleaning the spray arms
The spray arms should be cleaned regularly to prevent clogging of the jets and
bearings due to limescale or other hard water chemicals. Proceed as follows (Fig. 24):
Cleaning the exterior of the appliance
Clean the door seals regularly with a soft damp cloth to remove food deposits.
When the dishwasher is being loaded, food and drink residues may drip onto the sides
of the dishwasher door. These surfaces are outside the wash cabinet and are not
accessed by water from the spray arms. It is therefore important that you wipe off any
deposits before you close the door.
If the control panel is dirty, wipe it with a soft, damp cloth only and dry thoroughly.
CAUTION!
• To prevent penetration of water into the door lock and electrical components, do
not use a spray cleaner of any kind.
• Never use sharp objects, harsh or abrasive cleaners or scouring pads on any
dishwasher surface because they will scratch the finish. Some papers towels
may also scratch or leave marks on the surface.
Fig. 24
To remove the upper spray
arm, hold the nut and
rotate the arm clockwise to
remove it.
To remove the lower spray
arm, pull out the spray arm
upwards. Wash the arms in
warm, soapy water.
Use a soft brush to clean
the jets. Replace them after
rinsing them thoroughly.