User Manual

After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | [e-mail]
11
Installation (Cont.)
Levelling the machine
Place the machine on solid, dry and level ground. The machine must stand perfectly
level on all four feet to ensure safe and proper operation. Incorrect installation may
cause vibrations and noise and may cause the machine to move about.
To determine whether levelling is necessary, place a spirit level on top of the washer
and hold it upright against the housing to identify any inclinations. If the machine
needs levelling, proceed as follows (Fig. 4):
WARNING!
It is very important to level the washing machine carefully, especially if your floor is
uneven. Failure to do so may result in the machine shaking and moving during the
spin cycle, or out-of-balance problems.
WARNING!
The lock nuts on all four feet must be screwed tightly against the housing, otherwise
the machine may vibrate noisily during operation.
Locknuts
Adjustable feet
Lock nuts
Adjustable feet
Fig. 4
• Loosen the lock nut with a spanner, turning it anticlockwise to loosen.
• Adjust the foot by hand until it makes close contact with the floor. Turn it
clockwise to lower the foot or anticlockwise to raise it.
• When the machine is level, use a spanner to turn the lock nut in a clockwise
direction to tighten.