User Manual

After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | [e-mail]
13
Installation (Cont.)
WARNING!
• Never lay down the drain hose as water will be discharged.
• Be sure the drain hose is properly routed so it will not kink or lift off the sink.
• Leave the drain hose affixed to the back of the machine.
Fig. 6
Drain hose connection into a standpipe (Fig. 6)
• Firstly, form a hook in the end of the drain hose using the supplied drain hose elbow.
• Place the drain hose into your standpipe, which should have an internal diameter
of approximately 30mm, thus ensuring there is an air break between the drain hose
and standpipe.
• When discharging into a standpipe, ensure that the top of the standpipe is no more
than 90cm and no less than 60cm above floor level.
FROST PROTECTION
• Do not install the washing machine in places where temperatures drop to below
0°C. The reliability of the electronic control unit may be impaired at temperatures
below freezing point, and the machine’s inlet valve and draining systems may get
damaged as frozen hoses may burst or split.
• If temperatures drops to below 0°C, transfer it to an area with a warmer ambient
temperature before use and ensure no residual water is frozen in hoses and pipes.