Operator`s manual
114
Chapter 10: Project Management (Project Mode)
Follow the steps below to write a Project to a CD-R/CD-RW disc.
➸
NOTE :
Before starting the steps below, check the Disk mode main screen to see if the DPS16 recognizes
the CD-R/CD-RW drive connected to the SCSI connector. (For more information on Disk mode, see page
125.) Also, insert a CD-R/CD-RW disc into the CD-R/CD-RW drive.
1. On the Project screen, select a Project to write onto the disc as the current Project.
2. Press the [F2] ( CD-R) key.
The following screen appears.
5
1
3
4
2
6
7
(x2)
1 Target project
Displays the name of the current Project.
2 Track to write L/R
Selects physical tracks (1-16) of the DPS16 you wish to write into the L/R channels of the disc.
3 Region ( IN-OUT/ALL)
Specify the region of the data you wish to write.
4 Write speed ( MAX/SLOW(x1)/FAST(x2)/x3/x4)
Specify the writing speed here. When MAX is selected, the fastest speed of the connected drive available
(within x1 to x4) will be used.
5 This area displays the information which is on the disc in the CD-R/CD-RW drive.
• Disc status (NOT FINISHED/FINISHED/NO DISC)
The Finish process is a process of writing readout information to a disc (see page 117). “ NOT FIN-
ISHED” appears if the Finish process has not been performed. “FINISHED” appears if the Finish process
has already been performed. “ NO DISC” appears if no disc is inserted in the drive.
• Total track ...... Displays the total number of tracks on the disc.
• Total time ........ Indicates the total time recorded on the disc.
• Free ....................... Indicates the time available on the disc.
6 Write length
Indicates the length of the actual recording data.
7 Test write (ON/OFF)
This field allows you to select whether or not to perform test writing (ON) before actually writing the data onto
the disc. (see “ Test write” on page 115)
3. Move the cursor to the Track to write L/R field (2) and set the DPS16 track numbers (1-16) to
be stored in the L/R channels of the disc.
• When you set the track numbers in the L/R fields, the track name specified in V.Track mode (see page 60)
appears on the right.
• If you wish to write mono data, select the same track number for the L and R channels.