Operator`s manual

48
Chapter 3: Transport/Locate Operation
■ Using the stored direct locate points
1. Press the [GO TO] key while the DPS16 is stopped.
The Locate List window appears.
2. Press the [IN] key or the [OUT] key.
The DPS16 locates the point stored in the key you pressed and closes the window.
Repeat function
The Repeat function plays back data between the IN point and the OUT point repeatedly.
1. Press the [F4] ( SELECT) key and turn the [JOG] wheel to select the AUTO PUNCH function.
2. Press the [F1] ( REPEAT) key to set the REPEAT parameter to ON.
Now the Repeat function is enabled.
3. Press the [ ] button.
The data between the IN point and the OUT point is repeatedly played.
If you start playing back from a position preceding the OUT point, the playback continues up to the OUT
point, then returns to the IN point, and the data between the IN and OUT points is repeatedly played. If you
start playing back from a position after the OUT point, the DPS16 locates the IN point first, then starts
playback.