Operator`s manual

12: Hard Disks
Page 100
Checking for Disks
To check the status of a hard disk connected to SCSI-A bus:
1) Press the SUB-MENU key.
The indicator in the key will flash and the text “SUB-MENU” will appear on the display.
2) Press the 1(DISK) key – numeric keypad.
The message “TIME” will appear on the display.
3) Use the JOG/SHUTTLE control to select the Disks function.
You will see a display similar to the following:
ABS
S-M
4) Press the STORE/ENT key.
The message “SCANNING” will momentarily appear on the display.
When the scan has completed, the DR16pro will display the SCSI ID of all the connected hard
disks, similar to the following:
ABS
S-M
Here are some other examples:
ABS
S-M
ABS
S-M
If you have connected a hard disk, but its SCSI ID does not appear, make sure that all SCSI IDs
are set correctly, all SCSI cables are connected correctly, and the hard disk is powered on.
This display indicates the DR16pro found one disk
at ID 0, the address of the internal hard disk.
This display indicates the DR16pro found one disk
at ID 0, but it is not correctly formatted.
This display indicates the DR16pro found no disks.
It probably indicates that the disk at ID 0 is not
connected properly.