Operator`s manual

11: Editing
Page 89
7) Use the CHANNEL ON keys (and the 9-16 key, if necessary) to select the copy source
tracks.
8) Use the TRACK REC (INPUT SELECT) keys (and the 9-16 key, if necessary) to select the
copy destination tracks.
9) Press the STORE/ENT key to execute the copy.
When the DR16pro has completed the copy operation, the message “DONE” will momen-
tarily appear on the display. The LED beside the EDIT key will switch off and the previous
mode will be restored.
Move
The move function is similar to the copy function. The difference is that the move operation deletes
the original section, leaving a gap on the source track. The following diagram illustrates the move
procedure:
Destination insert point
"in" point "out" point
Destination insert point
Source Track
Destination Track
Source and Destination Track
TIME
Source Section
Source
Section
The following steps are similar to “Copy” on page 86, therefore only an outline is provided here.
1) Set the “in” and “out” points to define the move source section.
See “Specifying the “in” Point and “out” Point” on page 26.
2) Locate to the desired position for the destination insert point.
Refer to the “Locate Functions” on page 77.
3) Press the EDIT key to enter Edit Mode.
The EDIT indicator will light up
4) Use the JOG/SHUTTLE control to select the Move function.
You will see a display similar to the following:
ABS
EDIT
5) Press the STORE/ENT key.
6) Use the JOG/SHUTTLE control to specify the number of repeats.