Operator`s manual

Version 1.21 91
/ EDIT PROGRAM
MODWHEEL Sets the amount of modulation that will be introduced by the modwheel.
AFTER TOUCH This allows you to introduce vibrato using aftertouch.
GOTO DEST This pops up a list of destinations the LFO may be assigned to for quick
and easy access to their pages.
GOTO SOURCE When any of the mod input parameters are selected, pressing this key
will take you directly to the controller’s page.
NOTE: If a mod parameter is not selected, you will receive a dialogue prompt advising you of
this. Similarly, if the mod source is one of the MIDI controllers, you will receive the same pop-
up prompt.
LFO 2
LFO 1 gives you access the LFO 2 via F7. Pressing this will show this screen:
The parameters are:
RATE Sets the speed of the LFO. The range is very slow (at a setting of 0, it
takes over a minute to complete a full cycle) to very fast (around 100Hz).
An average vibrato rate setting is around 45.
DELAY This sets the time it takes for the modulation to fade in.
DEPTH Sets the initial depth of the modulation. This should be set to a value if
you want LFO1 modulation permanently on the sound (if you only want
to introduce vibrato or other modulation effects via the modwheel
however, this parameter should be set to 0 and the MODWHEEL
parameter - see below - should be set to a suitable value).
WAVEFORM Nine modulation waveforms are available. These are
SINE
A smooth waveform suitable for vibrato. Also useful
for slow, smooth panning and filter sweeps.
TRIANGLE
Another waveform suitable for vibrato and slow
sweep effects.