Operator`s manual

160 Version 1.21
EDIT SAMPLE /
MIX
Again, the MIX page does not conform to the usual page layout:
As in JOIN, use F1 and F9 to select the samples you want to mix. The process will merge the two
samples, effectively ‘layering’ them into one composite sample.
The parameters are:
SAMPLE A/B FROM These parameters allow you to set the start point for the two samples.
SAMPLE A/B TO These parameters allow you to set the end point for the two samples.
SAMPLE A/B LEVEL These parameters allow you to set the level of both samples.
PLAY SAMPLE A/B These two keys allow you to audition the two samples A and B prior to
committing the join function.
MAKE STEREO This allows you to make a stereo mix out of two mono samples and will
place Sample A on the left and Sample B on the right. Pressing it will
show the usual off-line processing display followed by this prompt:
Because there are two originals with this process, you have the
opportunity to play each one before deciding to keep or discard them. If
in doubt, press KEEP ALL and decide what to do with the originals
afterwards
You may, of course, rename the new sample to something you prefer.