Operator`s manual

Version 1.21 203
/ FX
RIGHT SEMITONE Sets the right channel’s pitch shift in semitone increments.
RIGHT FINE Allows you to fine tune the right channel’s tuning.
RIGHT DELAY Sets the delay time for the right channel’s feedback.
RIGHT FEEDBACK Sets the amount of feedback for the right channel.
NOTE: When PITCH+FEEDBACK is selected, this uses the delay line normally used for delay/
echo effects (you will note that the DDL section in the multiFX block diagram is also highlighted
when PITCH+FEEDBACK is selected to indicate this).
In other words, the delay/echo effects described next are not available when
PITCH+FEEDBACK is selected.
Attempting to access the DELAY FX in the main MULTIFX page in this case will pop up this
dialogue:
If you want to use the delay effects, please select another modulation effect type.
In all the modulation effects types, the ACTIVE switch on F10 allows you to bypass the selected
effect from the chain of effects.
MODULATION EFFECTS TEMPLATES
A wide variety of templates are offered that cover the whole range of modulation effects from mild
chorus to thick flanging to rotary speakers, autopan, tremolo, pitch shift and many other special
effects. These can be used ‘as is’ or can be edited and used as the basis for your own effects.
Simply select a template that is close to what you want and make the necessary tweaks to it for
your own requirements.