Operator`s manual

218 Version 1.21
SAVE /
Pressing EXECUTE will pop-up a progress display:
Assuming you chose to save the programs and samples as well, you will see these being saved.
When saving an item, assuming CHECK NAMES is switched on and something of the same name
exists in the currently selected folder, you will receive this prompt:
Pressing YES will replace the item on disk with the item you are saving. Pressing SKIP will keep
the original on disk and will not save the new item.
If you press SKIP, the next time an item of the same name is found in the folder, you will receive the
same prompt again. However, pressing YES TO ALL will replace all items that may have the same
name without you receiving any further prompting.
If in any doubt at all, press CANCEL SAVE and re-appraise the situation before you save to prevent
accidentally overwriting anything valuable on disk.
NOTES REGARDING SAVE
• You may only save to an MS-DOS formatted disk. This includes hard disk, removable disks
(Jaz, Zip, Syquest, etc.) and floppy disk.
• Whilst you can load data from an S1000, S1100, S2000, S3000 or XL series hard disk, it is not
possible to save data to these or other Akai formatted disks.
NOTE: Similarly, you cannot record ‘virtual’ samples to anything other than an MS-DOS
formatted disk.