Operator`s manual

246 Version 1.21
VIRTUAL SAMPLES /
Once you have selected where the new recording will be placed, return to the main RECORD
page (press RECORD SETUP - F14 - or the main RECORD mode key), set the record parameters
as appropriate and record as normal. The whole process is exactly the same and you will receive
exactly the same prompts:
However, please note that due to the slowness of disk drives (and depending on the length of the
disk recording you made), you will find that the display of the new recording’s waveform at the end
of the record process takes some time. Much of this will depend on the speed of your drive (faster
drives will give a better performance, of course) and the length of the recording.
IMPORTANT NOTE: You can only record to MS-DOS formatted hard disks. It is not possible
to record to old S1000, S1100, S2000, S3000 or XL series formatted disks.