Installation Guide

Symptom Possible Cause Solution
No ignition spark.
Dead batteries or ignition module failed.
CAUTION
Replace batteries and attempt ignition. If there is still
no spark ignition, the appliance burners can still be
used.
To light them:
eader,
push in on the control knob and turn
counterclockwise to LIGHT.
ning all the way round
the burner, you may adjust the heat.
1
2
Care and Cleaning
34
Ranges:
Control Panel, Door Handle, Control Housing
Clean the control panel, door handle and control
housing with a solution of mild detergent and warm
water.
Do not use abrasive cleaners or scrubbers; they will
Dry the components with a soft, lint-free cloth.
Oven Window
Clean all glass surfaces with a solution of mild detergent
and hot water. Use a mild glass cleaner to remove
Dry completely with a soft, lint-free cloth.
Porcelain Surfaces
Clean oven interior and inner door liners with a solution
of mild detergent and hot water.
Rinse and dry with a soft cloth. Do not use abrasives or
commercial oven cleaners.
Oven Racks
Clean oven racks with solution of detergent and hot
water. To clean heavy soil, use a scouring pad such as
steel wool with plenty of water.
Oven Frame
cleaners. Rinse well with clean water and dry.
Oven Gasket
oven door gasket cannot withstand abrasion.
It is necessary for the gasket to remain intact.
Outer Oven Door
Use soap and water to thoroughly clean the top, sides
and front of the oven door. Rinse well. You may also use
a glass cleaner to clean the glass on the outside of the
door.
Do not use oven cleaners, cleansing powders of harsh
abrasives on the outside of the door.
Inner Oven Door
Do not allow excess water to run into any holes or slots
in the door. Any soap left on the liner causes additional
stains when the oven is heated.
Before you call for service, please review the potential
problem / possible causes and remedies shown in the
table below.