Service manual

23
Model No: AC-S10CK_S10HK
Version 1.0
2. DRILL THE PIPING HOLE WITH 70mm DIAMETER HOLE-CORE DRILL
l Line according to the arrows marked on the lower left and right side of the in-
stallation plate.
l The meeting point of the extended line is the center of the hole.
l Drill the piping hole at either the right or the left and the hole should be slightly
slant to the outdoor side.
3. PIPING AND DRAINAGE OF INDOOR UNIT
l Preparation of piping
1) Cut the pipes and the cable
F Use the accessory piping kit or the pipes purchased locally.
F Measure the distance between the indoor and the outdoor units.
F Cut the pipes a little longer than measured distance.
Downloaded from AC-Manual.com Manuals