User Manual

Storage

46 BKS 4540

Guide bar

Reverse the bar occasionally to prevent partial

wear.

The bar rail should always be a square. Check

for wear of the bar rail. Apply a ruler to the bar

and the outside of a cutter. If a gap is observed

between them, the rail is normal. Otherwise, the

bar rail is worn. Such a bar needs to be correc-

ted or replaced.

(1) Ruler (2) Gap (3) No gap (4) Chain

tilts

WARNING!

The table contains a list of all possible combinations between bar and chain, indicating those

which may be used on each machine, marked with the symbol “*”.

Pitch Guide bar Chain Chain saw

model

Zoll Length In-

ches/cm

Groove width

Inches/mm

Code Code BKS 4540

0.325” 16”/40cm 0.058”/1.5mm Oregon

168PXBK095

Oregon

21BPX066X

For replacement use only above bars and chains. If you use non-approved combinations it may cause

serious personal injury and damage to the machine.

STORAGE

1 Empty the fuel tank and run the engine out of fuel.

2 Empty the oil tank.

3 Clean the entire unit.

4 Store the unit in a dry place out of the reach of children.

5 Putting the cover of the guide rail on always at storage and transportation.

WASTE DISPOSAL AND ENVIRONMENTAL PROTECTION

Never pour remainders of chain lubricant or 2-stroke fuel mixture in the drain or sewerage system or soil,

but dispose of it in a proper, environmentally friendly way, e.g., at a special collecting point or dump.

If your device should become useless somewhere in the future or you do not need it any longer, do not

dispose of the device together with your domestic refuse, but dispose of it in an environmentally friendly

manner. Thoroughly empty the oil/lubricant and fuel tanks and dispose of the remainders at a special

collecting point or dump. Please also dispose of the device itself at an according collecting/recycling

point. By doing so, plastic and metal parts can be separated and recycled. Information concerning the

disposal of materials and devices are available from your local administration.