Owner`s manual

16
Notes:
l To select bank 10, press 0.
l If you select a bank that does not contain any empty channels, a bar flashes
under the bank number, and A-FULL and AUTO appear. To enter new
frequencies into this bank, you must delete one or more frequencies stored in it,
then repeat Step 2. See "Deleting Frequencies" on Page 22.
l If you want to select the bank, press the bank's number again. The bar under the
bank appears.
l If you select more than one bank and want to review the number of empty
channels in each bank, press AUTO or turn TUNE knob to selected the bank you
want to review.
3. Press LIMIT. L appears.
4. Use the number keys to enter the lower limit of the frequency range you want to
search, then press ENTER.
Note: If you enter an invalid frequency in Step 4 or 6, the scanner displays Error.
Simply repeat the step.
5. Press LIMIT. H appears.
6. Use the number keys to enter the upper limit of the frequency range you want to
search, then press ENTER.
7. Press /\ to search from the lower to the upper limit, or \/ to search from the upper to
the lower limit. AUTO and the bar under the currently selected bank number flash on
the display.
When the scanner finds an active frequency, it stores the frequency in the displayed
channel, then continues searching for more active frequencies, storing them in any
subsequent empty channels. When the scanner fills all channels within the selected
banks, the scanner beeps rapidly and displays the number of the last channel where
a frequency was stored.
Note: During auto store, you can manually change the receive mode. See "Changing
the AM/FM/WFM Receive Mode" on Page 27. If you select WFM, the scanner
searches frequencies at 50 kHz steps.
8. To pause auto store, press AUTO. The scanner displays the last channel number
where a frequency was stored. To continue auto store, press /\ or \/.
9. To stop auto store, press MAN. MANUAL appears.