Owner`s manual

18
3. When the scanner find an active frequency, it stops searching and displays that
frequency's number.
To store that frequency in the channel, simply press ENTER. The scanner stores the
frequency, then continue the searching.
Note: When you store frequency while all channels are entered, CH FULL appears.
In order to store more frequencies, you must clear some channels. See "Deleting
Frequencies" on Page 22.
4. To store that frequency in the monitor memory, simply press MON. To search for
another active frequency in the selected band, press and hold /\ or \/ for about a
second, then repeat Steps 3 or 4.
To select a different band then search for another active frequency, repeat Steps 2-4.
Limit Search
You can search for transmissions within a range of frequencies you select, called the
limit search range. You can set and store up to ten limit search ranges into search
banks (1-10).
Notes:
l You can use the scanner's delay feature while using limit search. See "Delay" on
Page 22.
l During the limit search, you can manually change the receive mode. See
"Changing the AM/FM/WFM Receive Mode." If you select WFM, the scanner
searches frequencies at 50 kHz steps.
Follow these steps to set and store limit search ranges and search them for active
frequencies.
1. Press PGM. PGM appears.
2. Using the number keys, select the number for the search bank where you want to
store a limit search range.
3. Press LIMIT. SEARCH BANK, selected search bank number and L appear, and a
bar flashes under the selected search bank's number.