Owner`s manual

22
To begin scanning channels or to start scanning again after monitoring a specific
channel, press SCAN.
Notes:
l You must store frequencies into channels before the scanner can scan them (see
"Searching For and Storing Active Frequencies" on Page 13).
l The scanner does not scan empty channels.
The scanner scans through all channels (except those you have locked out) in the
active banks (see "Locking Out Channels and Frequencies" on Page 25 and "Turning
Channel-Storage Banks Off and On" on Page 21).
To change the scanning direction, press /\ or \/.
SEEK SCAN/SEARCH
You can scan or search frequencies monitoring transmit about 5 second. After 5
second, the scanner start automatically scan/search to the next transmit.
Seek Scan
Follow these steps to seek scan on or off.
1. Press FUNC. FUNC flushes on the display about 5 seconds.
2. Press SCAN while FUNC flushes.
Seek Search
Follow these steps to seek search on or off.
1. Press FUNC. FUNC flushes on the display about 5 seconds.
2. Press BAND or LIMIT or DIRECT/• to enter each search mode while FUNC
flushes.
3. Press /\ or \/ to start search.