Specifications

English 97
the specific frequencies used in your area. The scanner is
preprogrammed with all the frequencies allocated to these services.
To start a Service Search, press Func then Srch/Svc. When the
scanner finds a transmission, it stops on it. When the transmission ends,
the scanner resumes searching according to the search delay (see page
100).
During a Service Search, the upper line displays the current service
name. The lower line displays the search frequency and the direction
indicator (↑or ↓) with the modulation.
Enabled service banks appear on the lowest line. Disabled service bank
numbers are not displayed. The currently searched bank number
flashes. You can turn service banks on/off by using1-7; however, one
service bank must always be enabled. If you turn off all service banks,
the scanner will display Nothing to Srch.
If you want to change the search direction or if it is a long transmission
and you want to continue searching, turn the SCROLL CONTROL or
press Func then Srch/Svc.
Service Search Receive/Hold Modes
To hold on a frequency, press Hold. To step through the frequencies,
turn SCROLL CONTROL while in Hold mode. Press Hold to resume.
While monitoring a transmission, the upper line displays the current
service bank name and the lower line displays the channel number (if
defined) and current frequency with the direction indicator (↑or ↓).
The modulation, Priority mode icon (if Priority is enabled), any
CTCSS/DCS received (if enabled), and the Close Call icon (if CC Pri or
CC-DND is enabled) will also appear in the display.
Numbers at the bottom of the display show the enabled service search
banks. The currently searched bank number flashes in Receive mode.
To store a frequency, press Pgm/E. (see Storing Found Search
Frequencies on page 102.)
To temporarily lock out a frequency, press L/O.