Instruction Manual

ELECTRICAL CONNECTIONS

WARNING: To avoid possible electrical shock, be sure you have turned

o the power at the main circuit panel.

Follow the steps below to connect the fan to your household wiring.

Use the wire connecting nuts suppled with your fan. Secure the

connectors with electrical tape. Make sure there are no loose wire

strands or connections.

NOTE: The dip switches on the receiver are covered with a rubber

cover, remove the rubber cover and then have it replaced after making

any changes to the dip switches.

NOTE: The CoolTouch™ Control System is equipped with 16 possible

frequency combinations to prevent interference from or with other

remote control units. The frequency switches on your receiver and

transmitter have been preset at the factory. Please recheck to make

sure the switches on transmitter and receiver are set to the same

position, any combination of settings will operate the fan as long as the

transmitter and receiver are set to the same position. (Fig. 12)

Step 1. Insert the receiver into the ceiling mounting bracket with the

flat side of the receiver facing the ceiling. (Fig. 13) For best

performance, make sure the Black Antenna, on the end of the

receiver, remains extended and not tangled with any of the electrical

wires.

Receiver

Hanger

bracket

Fig. 12

Fig. 13

Code switch

MED

LOW

REV

FAN OFF

LIGHT

ON ECE

1234

ON ECE

1234