Instruction Manual

INSTALLING THE MOUNTING

PLATE

Fig. 16

Step 1. Loosen the two screws on the mounting ring attached to the

motor shaft and "remove" and save the third screw. (Fig. 17)

Step 2. Place the key hole slots on the mounting plate over the two

screws previously loosened on the mounting ring.

Turn the mounting plate until is locks in place at the narrow section

of the key hole slots.

Tighten both key hole screws and replace the third screw previously

removed and tighten securely.

ATTACHING THE FAN BLADES

Step 1. Attach a blade to a blade bracket using the screws, spring

washers and fiber washers provided. (Fig. 16)

Make sure the blade is straight when set on the blade bracket.

Tighten each mounting screw and then repeat this procedure for

each blade.

Step 2. Attach each blade assembly to the motor using the

"Pre-Installed" mounting screws in the blade bracket. (Fig 16)

Fig. 17

Screws

Blades

Blade brackets

Screws

Spring

washers

Fiber

Washers

Mounting plate

Mounting ring

Screws