Instruction Manual

Fig. 18
INSTALLING THE SWITCH HOUSING
NOTE: Before starting installation, disconnect the power by turning
o the circuit breaker or removing the fuse at fuse box.
Step 1. Loosen the 3 screws from the mounting plate.
Step 2. Raise and hold the switch housing close to the mounting
plate. Push the nine pin square wire connectors together. One from
the fan and one from the switch housing. (Fig. 18)
Step 3. Tuck the connections neatly into the switch housing and
switch housing to the ceiling fan. Place the key hole slots on the top
edge of the switch housing over the mounting screw heads on the
mounting plate. Turn the switch housing until the screw heads are
at the narrow end of the key hole slots. (Fig.18) Tighten all of the
screws.
Switch
housing
Screws
Mounting plate
Connection plugs
| 14