Instruction Manual

Fig. 20

Fig. 21

Remove the face plate of the Wall Switch by lifting at the top and

then insert the supplied 12V battery. Duracell MN21/Eveready

A23/GP 23A all 12V.

Replace the switch face plate.

To prevent possible damage to the transmitter, remove these

batteries if not used for long periods of time (months).

HI Button = High Speed

MED Button = Medium Speed

LOW Button = Low Speed

FAN OFF Button = Motor O

Light Button (If equipped) = the "LIGHT" button turns the light ON

or OFF and also controls the brightness setting. (Fig. 21)

Press and hold either button to set the desired brightness level. The

next time you turn the light on, the system will remember this

setting.

Press and release either button to turn the light ON or OFF.

Reverse button "REV":

When the fan is running, press and release the Reverse button one time,

the fan will change operating direction.

INSTALLING THE BATTERIES

ON ECE

1234

23AE 12V

OPERATING INSTRUCTIONS