SOLAR LAMP POST With Solar Bulb US Patent # 7172307 Solar Bulb is Patent Pending Instruction Manual
Introduction Thank you for your purchase. Our solar charged accent lighting eliminates the problems associated with most solar lighting available today. Our solar charged lights are brighter and last all night with a typical solar charge. Unique design, superior light output and numerous installation options confirm the outstanding value of the product. The company also offers unique multi-purpose rechargeable products that range from party lights to emergency lighting products.
WARNING: These Light bulbs are not to be used in other electrical sockets these are low-voltage light bulbs that are built and designed for our products only! Tools that are needed but not supplied with the high post lamps are: a screw driver, a wrench and an electrical drill that will be used to anchor the lamp base to the ground.
Installation Instructions: 1. Mark and drill three holes, into a solid surface no smaller than the fastening screws. The holes shall be lined up with the holes of the lamp base (D). 2. Put the fastening screws (included) into the drilled holes with their threaded ends facing up (Fig. 2). 3. Place lamp base onto fastening screws and secure base with the nuts using a wrench (Fig. 3). 4. Make sure the lamp base (D) is stable before installing Part (E). 5.
Installation Instructions: Use electric drill to make two holes in the desired surface, place provided anchors into holes, place the base (L) in line with the holes and screw the provided screws. Installation Instructions: NOTE: If you are replacing an existing gas/electric post light, you must consult a certified technician to cancel them before installation. Place Part (M) on top of your existing 3” post and tighten the 3 screws provided to secure the lamp.
Warning Do not dispose of Li-Ion battery in the regular trash, municipal waste stream or by fire as batteries may leak or explode. Do not open, short circuit, or mutilate batteries as injury may occur. Preserve our environment by recycling Li-Ion batteries or disposing of them in accordance with local, State and federal regulations. Do not mix old and new batteries. Maintenance Clean the solar panel regularly with a damp towel to guarantee optimum performance of the solar panel.