User Manual

PLAN AN ESCAPE ROUTE:
• Make a map and mark all locations of doors and windows and a possible escape route.
Note that you may need an escape ladder on high oors.
• Ensure everyone in the house knows the sound the smoke alarms produce and regularly
practice use of the escape route.
• Leave the house immediately according to the plan when hearing the alarm. Every
second counts: so respond quickly. If you do not notice smoke or heat, check if everyone
in the house is in a secure location.
• Do not open any doors without feeling wether the door is warm or if there is smoke
coming from underneath the doors. If it is, do not open that door. If the door is cold, put
your shoulder rmly against the door and open it a small amount to check for any heat
or smoke rst.
• If there is much smoke, keep low and take shallow breaths, preferably through a moist
towel. Call the re department as soon as you are safe outside.
REPLACING THE BATTERIES:
The detector is supplied using a 9Volt blok battery. Only use the recom-
mended type Gold Peak 1604A or Duracell MN1604. Under normal
conditions the battery will last at least one year. If it is about to need re-
placement, the smoke detector will make a chirping sound every 30 to 40
seconds for at least 30 days. Pay attention to the polarity when replacing
batteries. Test the detector after every battery replacement. If the smoke
detector does not function, please contact your supplier.
ENVIRONMENT:
Do not throw away used batteries, but recycle them using your local chemical depot. The
product may not be thrown out as normal waste, but must be recycled as electrical waste.
DECLARATION OF Performance:
Is available at the following internet address:
http://DOC.hesdo.com/SA20_DOP_1.pdf