MSDS

iLoveToCreate Material Safety Data Sheet – Aleene’s Original Tacky Glue
Page 2 of 6
5. FIRE FIGHTING MEASURES
Autoignition Temperature:
Not Available
Flash Point:
> 212
o
F
Upper Explosive Limit (%):
Not Applicable
Lower Explosive Limit (%):
Not Applicable
Extinguisher Media:
CO2, Dry Chemical, Foam – Use extinguishing
media appropriate for surrounding fire
Special Firefighting Procedures:
Fire fighters should be equipped with self-
contained breathing apparatus to protect
against potentially toxic and irritating fumes.
Fire & Explosion Hazards:
This is a water-based product and presents no
particular fire or explosion hazard. Dry polymer
film will burn. Product contains low level of
organic volatiles which may be emitted at
elevated temperatures.
NFPA Flammability Hazard Class:
0 = Insignificant
6. ACCIDENTAL RELEASE MEASURES
Spill or Leak Procedures:
Absorb spillages onto sand, earth or any suitable absorbent material.
Sweep up and shovel into waste drums. Wash the spillage area with
water. Washings must be prevented from entering surface water drains.
Disposal should be in accordance with local, state or national legislation.
For safety and environmental precautions, please review entire Material Safety Data Sheet for
necessary information.
7. HANDLING AND STORAGE
Storage
Temperature:
40 - 100 F
Handling /
Storage:
Avoid extreme temperatures. Protect from freezing. This material should not be
spilled, discharged, or flushed into sewers or public waterways. Product contains low
level of organic volatiles which could accumulate in the unvented headspace of
drums or bulk storage vessels. Open drums in well ventilated area. Avoid breathing
vapors.
Ventilation
Requirements:
General
8. EXPOSURE CONTROL AND PERSONAL PROTECTION
Conditions Under Which Personal
Protective Equipment Required:
Normal work conditions, maintenance / repair
Eye Protection Requirements:
Wear safety glasses with side shields; protect against splashing
Glove Requirements:
The use of chemically resistant gloves is recommended.
Clothing Requirements:
Uniforms, coveralls, or a lab coat should be worn. Rubber
boots and apron should be worn if exposure is severe.
Change / Removal of Clothing:
Remove contaminated clothing and launder before reuse.
Wash Requirements:
Wash before eating, drinking, or using toilet facilities.
Respirator Requirements:
None required under normal handling conditions. Use NIOSH
approved respirator if vapor or mist levels are irritating.
Ventilation Requirements:
General