Integration Instructions

4/14/2021 CONFIDENTIAL 2 of 2
this module. External antennas are not supported. As long as these 3 conditions
above are met, further transmitter tests will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.). The end-
product may need Verification testing, Declaration of Conformity testing, a
Permissive Class II Change or new Certification. Please involve a FCC certification
specialist in order to determine what will be exactly applicable for the end-product.
Validity of using the module certification:
In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization
for this module in combination with the host equipment is no longer considered
valid and the FCC ID of the module cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization. In
such cases, please involve a FCC certification specialist in order to determine if a
Permissive Class II Change or new Certification is required.
Upgrade Firmware:
The software provided for firmware upgrade will not be capable to affect any RF
parameters as certified for the FCC for this module, in order to prevent compliance
issues.
End product labeling: This transmitter module is authorized only for use in device
where the antenna may be installed such that 0 cm may be maintained between
the antenna and users. The final end product must be labeled in a visible area with
the following: “Contains FCC ID: U9YAL5808”.
Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user's manual of the end
product which integrates this module. The end user manual shall include all
required regulatory information/warning as show in this manual.
This device is authorized under 47 CFR 15.519 (the FCC Rules and Regulations).
The operation of this device is subject to the following restriction: This UWB device
shall transmit only when it is sending information to an associated receiver. This
UWB device shall cease transmission within 10 seconds unless it receives an
acknowledgement from the associated receiver that its transmission is being
received. An acknowledgement of reception must continue to be received by the
transmitting device at least every 10 seconds of operation or the UWB device must
cease transmitting