User's Manual

1600 PSI Pressure Washer

Automatic On / Off

The pressure washer is equipped with an automatic on/off switch.The pressure washer

will only run when the power switch is in the ON position and the trigger on the gun is

squeezed. When you release the trigger to stop spraying water through the gun, the

motor on the pressure washer will automatically shut off. Simply squeeze the trigger

again to resume using the washer. To stop using the pressure washer, release the

trigger and switch the unit to the OFF position. The unit should be turned completely

OFF while not in use or while unattended.

Bleeding The Gun

It is very important to bleed all the air out of the pressure washer before using it.To do this

1. Release trigger lock.

2. Squeeze the trigger before turning the electrical supply on.This removes any air trapped

inside the pressure washer and lance before using the units.

3. Continue holding trigger for approximately one minute to allow any excess air out of the

unit.Water will flow through the gun at low pressure during this procedure.

4. Lock the trigger.

5. Plug the mains power cable into the electricity supply.

6. Release the trigger lock.

7. Trun the ON/OFF switch clockwise to the I/ON position.

The pressure washer is ready to using now.

Gun Safety Lock

This pressure washer is equipped with a gun trigger safety lock. When not using the

pressure washer, use the safety lock to keep from accidentally engaging the high

pressure spray.

Adjustable Spray Nozzle

The adjustable nozzle will allow you to use any variety of spray patterns from a full fan

spray (Diagram 1) to a direct stream spray (Diagram 2). When using the pressure washer

to clean wood decks, siding, vehicles etc., always start using the fan spray and begin

spraying from a minimum 36” away to avoid damaging the surface of the material you are

cleaning. Always begin by spraying in a testing area free and clear of people and objects.