RPS15 Studio Console Power Supply USER GUIDE Publication AP8234
Limited One Year Manufacturers Warranty This product is warranted to be free from defects in materials or workmanship for period of one year from the date of purchase by the original owner. To ensure a high level of performance and reliability for which this equipment has been designed and manufactured, read this User Guide before operating. In the event of a failure, notify and return the defective unit to the place of purchase.
Important Safety Instructions WARNINGS - Read the following before proceeding : CAUTION ATTENTION: RISQUE DE CHOC ELECTRIQUE – NE PAS OUVRIR Read instructions: Retain these safety and operating instructions for future reference. Adhere to all warnings printed here and on the power supply unit. Follow the operating instructions printed in this User Guide. Do not remove covers: Operate the power supply unit with its covers correctly fitted.
Important Mains plug wiring instructions. The power supply unit is supplied with a moulded mains plug fitted to the AC mains power lead. Follow the instructions below if the mains plug has to be replaced.
Introduction This user guide presents a quick reference to the RPS15. We recommend that you read this fully before starting. Included is information on installing, connecting and operating the power supply unit along with panel drawings and technical specification. Whilst we believe the information in this guide to be reliable we do not assume responsibility for inaccuracies. We also reserve the right to make changes in the interest of further product development.
Installation Free standing The RPS15 can be operated as a freestanding unit for shelf or floor operation. Ensure adequate air flow around the unit. It must not be covered in any way. Always stand the unit on a firm flat surface well away from any soft furnishings or carpet. Rack mounting The RPS15 is designed as a 19 inch rack mount unit and will occupy 2U (3.5 inches) of rack space. The fast feet may need to be removed before rack mounting. Retain feet for future use.
Operating the RPS15 The RPS15 is internally wired to operate from one of the following standard settings: 100V, 120V, 220V, or 240V. The unit is shipped pre-wired for the country in which it is to be used. Check that the rear panel is marked to indicate the voltage that is correct for your territory. The power supply unit is provided with an IEC type mains connector and moulded mains plug. Check that this is correct for connection to your wall socket outlet.
Technical specification Mains Input Voltage Range: Internally wired for region: 100V +/- 10% 50/60Hz 120V +/- 10% 50/60Hz 220V +/- 10% 50/60Hz 240V +/- 10% 50/60Hz Note: Contact Allen & Heath if your local mains voltage is not shown above. Power consumption (max.) 650W Mains Fuse: 100/120V T10AL 250V 20mm A&H Part no: AL3455 220/240V T8AL 250V 20mm A&H Part no: AL0487 Internal Fuses: PCB Ident F1 (+17.5V) F2 (-17.5V) F3 (+48V) Fuse type T 16AL 250V 20mm T 16AL 250V 20mm T 1.