Installation Guide

INSTALLATION INSTRUCTIONS

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with

package contents list and hardware contents list. If any part is missing or damaged, do not attempt

to assemble the product.

Estimated Installation Time: 45 minutes (24 hours for silicone caulk to dry).

Tools Required for Installation (not included): Phillips screwdriver, utility knife or scissors, silicone

caulk, power drill with drill bit, measuring tape, level.

1. With 2 people, place the vanity on its back on

a flat, scratch free surface. Locate the Center

Support Leg (L) and screw into the base of the

vanity. Once complete, lift the vanity back up

into the upright position.

WARNING

Vanity (A) MUST be secured to the wall.

Note: Clean area where the vanity (A) will

be permanently located prior to beginning

installation, ensuring the vanity (A) will not

interfere with any water supply and drain

lines once mounted.

2. With two people, carefully place vanity (A)

against the wall in its final location. Find and

mark locations of wall studs behind the

permanent location of vanity (A).

From inside vanity (A), drill hole through

vanity mounting area into wall studs.

Using mounting hardware (not included)

appropriate for your installation site, secure

vanity (A) to wall stud. If possible, secure

vanity (A) to two wall studs for increased

stability.

Note: Use preassembled levelers on feet of

vanity (A) to level the item. Twisting the levelers

counterclockwise will increase the height of vanity

(A), twisting them clockwise will decrease it.