TM Roveland Bathroom Vanity 48-IN Vanity Base and Top ( 48-IN W x 22-IN D x 35-IN H) Date Purchased _______________________ Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-855-571-1044 9 a.m. - 5 p.m., EST, Monday-Friday. www.greentouchhome.
TM MODEL NUMBER DESCRIPTION 2026VA-48-200 2026VA-48-201 2026VA-48-202 2026VA-48-205 2026VA-48-242 48" Gray Painted Vanity Base & Sink 48" White Painted Vanity Base & Sink 48" Mahogany Vanity Base & Sink 48" Black Oak Vanity Base & Sink 48" Light Gray Finish Vanity Base & Sink 2500VT-48-900 2500VT-48-901 2500VT-48-904 2500VT-48-905 2500VT-48-906 48" Carrara Marble Top with Backsplash 48" White Quartz Top with Backsplash 48" Black Granite Top with Backsplash 48" Terrazzo Top with Backsplash 48" Dark Gray
PACKAGE CONTENTS C PART DESCRIPTION QUANTITY B Vanity Top 1 C Backsplash 1 D Sink 1 E Left Door (preassembled to Vanity (A)) 1 F Right Door (preassembled to Vanity (A)) 1 G Shelf 1 A B D 1 G A F E HARDWARE CONTENTS AA BB CC DD EE FF Bolt Qty. 4 Sink Bracket Qty. 4 Nut Qty. 4 Lock Washer Qty. 4 Wrench Qty. 1 Touch-up Pen Qty. 1 GG Shelf Pin Qty.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Installation Time: 45 minutes (24 hours for adhesive to dry). Tools Required for Installation (not included): Phillips screwdriver, utility knife or scissors, adhesive, power drill with drill bit, measuring tape, level INSTALLATION INSTRUCTIONS 1.
INSTALLATION INSTRUCTIONS 3. Screw bolts (AA) into the threaded holes of stone top (B) 3 AA D Hardware Used AA Bolt CK BA CK BA B x4 4. Lower the sink brackets (BB) over the bolts (AA) and allow to rest on the sink lip. Adjust location of bracket to firmly grasp sink lip. Lower lock washers (DD) over bolts (AA) and secure with nuts (CC). Hand tighten nuts (CC) with included wrench (EE).
INSTALLATION INSTRUCTIONS 5. To remove drawers preassembled in vanity (A). Fully extend drawers, locate plastic levers on metal glide tracks at left and right sides of drawer box, push on plastic levers on both sides at the same time, to disengage drawer box from the glides, Then gently lift the drawer up to remove it from the glide tracks. 5 A 2 1 6.
INSTALLATION INSTRUCTIONS 7. Using hardware appropriate for your wall type (not included), secure Vanity Cabinet (A) to two wall studs anywhere through the Vanity Mounting Plates. Be careful not to disturb any electrical or water lines that may be concealed in the wall. 7 WARNING Vanity (A) MUST be secured to the wall. A 8. To install the Top (B) to the vanity (A). Apply silicone adhesive to the top edge of the wood cabinet.
INSTALLATION INSTRUCTIONS 9. To reinstall drawers into vanity (A). Please fully extend metal glide tracks, gently lower and slide drawer box into rear glide catch, then, lower drawer box down to completely rest on extended glides, push plastic levers to lock the drawer box in place. Repeat for remaining drawers. Note: To Adjust the drawer box height. Please spin the adjustment wheel to the left to raise the drawer box or spin the adjustment wheel to the right to lower the drawer box.
INSTALLATION INSTRUCTIONS 11. If you need to adjust the doors, do so in the following manner. To adjust door up or down, loosen screws (a) on both hinges, adjust door, and retighten screws. To adjust door left or right, turn screws (b) on both hinges, in or out. To adjust door in or out, loosen screws (c) on both hinges, adjust door, and retighten screws. 11 2 2 2 2 2 2 a 1 a 3 1 1 12. Apply adhesive (not included) to unpolished side and bottom of backsplash (C).
CARE AND MAINTENANCE • • • • Dust the vanity regularly with a soft, non-lint producing cloth or household dusting product. You can clean the vanity with a gentle, non-abrasive household cleaner. Make sure to dry the wood immediately with a soft cloth or towel. The stone top can be cleaned using standard marble cleaning agents available at your local supplier. • Tips for using touch-up pen (FF): For scratches, stroke in direction of scratch. Rub off excess colorant promptly with a soft cloth.
REPLACEMENT PARTS FOR 2026VA-48-200 For replacement parts, call our customer service department at 1-855-571-1044, 9 a.m. - 5 p.m., EST, Monday - Friday.
REPLACEMENT PARTS FOR 2026VA-48-201 For replacement parts, call our customer service department at 1-855-571-1044, 9 a.m. - 5 p.m., EST, Monday - Friday.
REPLACEMENT PARTS FOR 2026VA-48-202 For replacement parts, call our customer service department at 1-855-571-1044, 9 a.m. - 5 p.m., EST, Monday - Friday.
REPLACEMENT PARTS FOR 2026VA-48-205 For replacement parts, call our customer service department at 1-855-571-1044, 9 a.m. - 5 p.m., EST, Monday - Friday.
REPLACEMENT PARTS FOR 2026VA-48-242 For replacement parts, call our customer service department at 1-855-571-1044, 9 a.m. - 5 p.m., EST, Monday - Friday.