Installation Guide

Lowes.com/allenandroth
ASSEMBLY INSTRUCTIONS
5
4. Position threaded nipple (C) in mounting bracket
(B) so that, when mounted:
• The threaded nipple (C) will protrude a
minimum of 1/4 inch beyond the raised center
portion of the bracket (B).
• The threaded nipple (C) height should be
positioned so that 1/2 the exterior threads of
the screw collar loop (I) will extend past the
canopy (A) when it is mounted.
5. Once the proper position of the threaded nipple
(C) and bracket (B) has been determined,
secure with hex nuts (D) as follows:
• Screw one hex nut (D) onto the threaded
nipple (C) and tighten against the raised
portion of the bracket (B).
• Screw another hex nut (D) onto the threaded
nipple (C) and tighten against the flat portion
of the mounting bracket (B).
• Screw the remaining hex nut (D) onto
threaded nipple (C) and tighten against the
screw collar loop (I).
3. Secure fixture loop (M) onto threaded pipe (N).
Screw threaded pipe (N) onto coupling (J).
Note: Be sure to pull the fixture wires through
the pipe and fixture loop, ensuring it is snug but
not too tight.
5
D
C
I
B
1/4 Inch
4
B
A
1/4 Inch
I
C
3
M
J
N