Installation Guide

8
IS35691-I2
Insert 1 in. tube plug (G) into 1 in. diameter
tube (B).
NOTE: Be sure to line up the indentations
in the 1 in. tube plug (G) with the holes in
the 1 in. diameter tube.
Repeat this step using the 7/8 in. tube
plug (F) and 7/8 in. diameter tube (A).
IMPORTANT: This step may be easier if
you insert a threaded sleeve (CC) through
the holes (only to be used as a guide)
before pushing the tube plug into place.
After inserting the tube plug, be sure to
remove the threaded sleeve (CC).
7.
Hardware Used
x 2
Threaded Sleeve
G
B
CC
CC
7
8.
Insert plastic rings (AA) into the end of
the 1 in. diameter tubes (B). Then, insert
the 7/8 in. diameter tube (A) into the 1 in.
diameter tubes (B).
Extend the tubes to the proper length to
fit between the 1 in. mounting bracket (E)
and 7/8 in. mounting bracket (D).
Hardware Used
x 2
Plastic Ring
8
AA
AA
A
B