Installation Guide

9
IS35691-I2
9.
Fasten the 1 in. diameter tube (B) to the 1
in. mounting bracket (E) using threaded
sleeves (CC) and end cap screws (BB).
Secure with large Allen wrench (FF).
Repeat this step for the 7/8 in. diameter
tube (A).
NOTE: To level the rod assembly, tighten
the preassembled set screws on the
mounting brackets with medium Allen
wrench (GG).
x 1
End Cap Screw
x 1
Threaded Sleeve
Hardware Used
Large Allen Wrench
9
CC
B
E
BB
FF
BB
CC
x 1
Medium Allen Wrench
GG
10.
Attach end caps (C) to 1 in. mounting
bracket (E) and 7/8 in. mounting bracket
(D) using set screws (II) at the top and
bottom. Adjust set screws (II) with small
Allen wrench (HH) as needed.
x 1
Small Allen Wrench
Hardware Used
HH
II
x 4
10
C
II
II
Set Screw
x 2