Installation Guide

allenandroth.com
7
Dial Adjustment:
• After 5 minutes in Test Mode, the sensor will
enter Auto Mode. Once in Auto Mode, the
Timer can be set using the Timer knob.
Note: The light was pre-set in the factory to
come on for 5 seconds every time motion is
detected; turn the knob clockwise to increase
the time -- up to a maximum 180 seconds.
- The sensor is more sensitive to motions
across its detection path rather than the
motions directly toward it.
Walk at normal
speed across the
detection area to determine
desired detection distance.
- The light will stay ON as long as the motion is
detected. Once movement has stopped, the
light will turn OFF after the delay time has
elapsed.
• When power is first applied, the light will
initialize
for 45 seconds and then will be in Test
Mode. The Test Mode will last for 5 minutes.
The adjustment dials (G) consist of two knobs
to adjust Sensitivity and Timer. During the Test
Mode, adjust the sensitivity to the desired
distance using the Sensitivity knob.
Note: The sensitivity was pre-set to the 40-ft.
maximum at the factory; turn the knob
counterclockwise to decrease the sensitivity --
down to a minimum of 5 ft.
G
G
A
Works At
Activated by
(Adjusted by
Sensitivity Knob)
When power is applied, the sensor
will initialize for 45 seconds and then
will be in Test Mode.
Night Only
The sensor switches to Auto
Mode 5 minutes after power
is applied.
Shut-o delay
(Adjusted by
Timer Knob)
5 seconds 5 seconds~180 seconds
Day and Night
Motion Motion
Mode Activation
TEST MODE AUTO MODE