Installation Guide

1. The gas pressure is low.
2. The cylinder is less than 1/4 full.
1. Turn the cylinder valve off and
replace the cylinder. Check the
burner ports for blockage.
2. Use a full gas cylinder.
15
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The burner will not
ignite.
The burner flame
is too low.
Carbon build-up
and/or thick black
smoke is present.
1. The gas cylinder is frosted over.
2. The openings are blocked.
3. The control knob is not in the “ON”
position.
4. There may be too many lava rocks
covering the burner bowl or small pieces
may be blocking the burner ports.
1. There is dirt or film on the reflector and
burner screen.
2. The burner is blocked.
1. Wait until gas cylinder warms up
and becomes unfrosted.
2. Clear the blockage.
3. Turn the control knob to the “ON”
position.
4. Remove a portion of the lava rocks.
Make sure the lava rocks just cover
the upper surface of the burner.
1. Clean the reflector and burner
screen.
2. Remove any blockage and clean
the burner inside and outside.