Installation Guide

ASSEMBLY INSTRUCTIONS
9
8
CC
AA
BB
A
9
Q
pilot box
Hardware Used
AA
x 4
M6 x 15 mm Bolt
BB
x 4
M6 Washer
CC
x 1
Hex screwdriver
Hardware Used
DD
x 1
M4 x 25 mm Bolt
WARNING
Keep children away during assembly, as this item
contains lava rocks, which are small pieces and
can be swallowed by children.
Place lava rocks (Q) around the burner, then
remove the label from the pilot box. A gas fire pit
requires 6.6 lbs. of lava rocks.
NOTE: DO NOT completely cover the burner
element or block the pilot box with the lava rocks.
During first use, preheat the lava rocks for 15
minutes to burn out the impurities and air in the
natural lava rocks to prevent from popping out.
9.
7
O
DD
O
Attach door handle (O) with bolt (DD), then use
Phillips screwdriver (not included) to screw
tightly.
7.
Place table top assembly (A) on a non-abrasive
flat surface to prevent scratching. Attach base
assembly to table top assembly (A) with bolts
(AA) and washers (BB) using hex screwdriver
(CC). Make sure the control panel is towards the
door (B).
NOTE: Tighten all bolts completely.
8.
control panel
B