Installation Guide

Proceed to ASSEMBLY INSTRUCTIONS on page 9 to
complete assembly.
8 9
ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
Hardware Used
1. Install the glass shelves (E) to the desired positions
with shelf clips (BB), making sure they are level.
2. Use the shelf hole plugs (CC) to seal the empty
holes.
3. Stick the bumpers (FF) at the two corners of the
door (D) opposite the door hinges (A).
1
2
3
Shelf Clip
Shelf Hole Plug
Bumper
x 12
x 20
x 2
BB
CC
FF
Note: These steps are applicable to both surface-mount installations and recess-mount installations.
E
BB
CC
FF
第 8 页 第 9 页
Lowes.com/allenandroth
Lowes.com/allenandroth
DD
GG
EE
RECESS-MOUNT INSTALLATION INSTRUCTIONS
Hardware Used
1. Determine desired location for cabinet (C), making
sure to place it where the door can swing freely without
obstruction and where no electrical or plumbling
obstacles would be behind the wall. Note: The height
of the cabinet (C) should be a minimum of 3 in. above
the faucet/vanity.
Using a reciprocating saw (not included), cut away a
rough opening of 14-2/5 in. x 25-1/2 in. x 3-7/8 in. into
the drywall.
2. Mark the opening size of the framing. Once the
drywall is cut, remove any framing in the rough
opening for the item, then frame the cutout opening as
illustrated.
3. Insert cabinet (C) into rough opening and make
sure it is level and plumb; use wood shims (not
included) as required. Then, secure both sides of
cabinet (C) to the studs from the inside using long
screws (GG) and washers (EE). Cover screw heads
with snap caps (DD).
1
2
3
Long Screw
x 4
GG
Snap Cap
Washer
x 4
x 4
DD
EE
CAUTION: This installation type is NOT applicable for solid-wall applications.
14-2/5in.
25-1/2in.