Installation Guide

Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall

Determine your desired location for installation and make a mark for the location of the mounting plate and CARD-58 CAP.

Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting

plate over mark made above. Make 4 marks where mounting screws will be placed as shown below. Drill hole at each of the

mark. (You may substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place

mounting plate over holes and secure to mounting surface using screws as shown below.

No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.

INSTALLATION INSTRUCTIONS

QN-24-5

MOUNTING PLATE

DRILLED HOLES

DETAIL A

BACKPLATE

DRILLED HOLE

ANCHOR

MOUNTING PLATE

SCREW

SET SCREW

BACKPLATE

PAGE 1
QN-24-5 INSTALLATION INSTRUCTIONS Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall Determine your desired location for installation and make a mark for the location of the mounting plate and CARD-58 CAP. Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark made above. Make 4 marks where mounting screws will be placed as shown below. Drill hole at each of the mark.
PAGE 2
QN-24-5 INSTALLATION INSTRUCTIONS Step1: Attach Bracket to Mounting Plate Place bracket on mounting plate and secure by tightening set screw as shown below. D BACKPLATE MOUNTING PLATE SET SCREW DETAIL D No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.