Installation Guide

DETAIL A
DETAIL B
A
B
Step1: Insert Bracket into Hole in the Wall
Cut a 5 1/4" x 5 1/4" hole in the wall. Holding the item so the two roller arms are closer to the top of the frame then the bottom,
loosen without removing, the two screws in the recess of the holder that attach the bracket. Slip the two ends of the bracket into
the hole in the wall.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
R-24C
Tighten the screws to secure the recessed unit into the hole in the wall. Screw the two cover caps onto the bushings on the
screws.
Step2: Attaching Unit to the Wall
5 1/4" x 5 1/4"
(Hole in the Wall)
SCREWS(X2)
BRACKET
BUSHING (X2)
CAP(2X)
R-24C