user manual

AT-TQ2403 Management Software User's Guide 155
If you do
have security configured on a client for properties of an unsecure network, the security settings
actually can prevent successful access to the network because of the mismatch between client and access
point security configurations.
To configure the client to not use any security, bring up the client Network Properties dialog and
configure the following settings.
Figure 61: Wireless Network Connection Properties Setting – No Security Setting
Association Tab
Field Setting
Network Authentication Open
Data Encryption Disabled
Configuring Static WEP Security on a Client
Static Wired Equivalent Privacy (WEP) encrypts data moving across a wireless network based on a static
(non-changing) key. The encryption algorithm is a "stream" cipher called RC4. The access point uses a
key to transmit data to the client stations. Each client must use that same key to decrypt data it receives
from the access point. Different clients can use different keys to transmit data to the access point. (Or
they can all use the same key, but this is less secure because it means one station can decrypt the data
being sent by another.)
If you configured the AT-TQ2403 Wireless Access Point to use Static WEP security mode…