user manual

208 AT-TQ2403 - Management Software - User's Guide
Feature or Setting CLI Command
Enable Remote Logging and Specify the Log
Relay Host for the Log
As a prerequisite to remote logging, the Log Relay Host
must be configured first as described in “Setting Up the Log
Relay Host”.
See complete explanation of CLI commands at
“Enable Remote Logging and Specify the Log Relay Host
for the Log”
Here are a few:
set log relay-enabled 1 -enables remote logging
set log relay-enabled 1 -disables remote logging
get log
set log -TAB TAB shows properties you can set
on the log
Get Transmit / Receive Statistics get interface all ip mac ssid tx-packets tx-bytes
tx-errors rx-packets rx-bytes rx-errors
Get Client Associations get association
Get Neighboring APs get clustered-ap
Get Information on the Management Interface for the AP
The following command returns all information on the internal interface for an access point:
AT-TQ2403# get management
Property Value
--------------------------------------------------------------------------------
vlan-id
interface br0
static-ip 192.168.1.230
static-mask 255.255.255.0
ip 192.168.1.230
mask 255.255.255.0
mac 00:01:02:03:02:00
dhcp-status down
management-ip-enabled 0
management-ip-address 192.168.1.1
deny-wlan-management-enabled 0
deny-wlan-management-ping 0
deny-wlan-management-telnet 0
deny-wlan-management-http 0
deny-wlan-management-snmp 0
deny-wlan-management-tftp 0